Dry installation on sand. Installation on sand maintains the drainage of the ground, allowing water to flow through the joints between the ceramic slabs. This dry installation solution is ideal where it is not possible to install a permanent paving or where there is a need to frequently change the layout of the paving. An exceptionally durable anti-slip product that is resistant to heavy loads, wear and weathering, XT20 stoneware is ideal for walkways and beach resorts.

Instructions for dry installation on sand

1. Substrate preparation
Create a layer of sand at least 5-10 cm deep and level it perfectly.

2. Laying surface
In dry installation on sand, the laying surface corresponds to the substrate.

3. Slab installation
Lay the slabs according to the chosen installation layout.

4. Creation of joints
The joints between the ceramic slabs should be chosen depending on the overall appearance required.